VS-42HN - Operating the VS-42HN 4x2 HDMI Matrix Switcher
13
6.3
Acquiring the EDID
You can acquire the EDID from OUT 1 and/or OUT 2 and copy it to any of the four
inputs, or reset to the default EDID. The EDID is acquired at once for all the inputs,
according to the status of the selector buttons.
To acquire or change the EDID of one or both new output displays
:
1. Connect the required acceptor to the output from which you want to acquire
the EDID.
2. Connect the power supply.
3. Press the EDID button and hold it for 3 seconds.
The four buttons that switch to the output from which you are acquiring the
EDID show their current state:
Input buttons that do not illuminate, store the default EDID
Input buttons that flash store the previously acquired EDID from the
OUT 1 or OUT 2 acceptor
4. For each input, select the output from which it will acquire the EDID, or
deselect it so it will reset to the default EDID value.
For example, to copy the EDID of output 2 to input 3, press the INPUT
SELECTOR button 3 on the TO OUTPUT 2 line.
5. Press the LOCK button.
The LOCK button and the INPUT buttons flash until the EDID is acquired.
6.3.1
Resetting to the Default EDID
To reset to the default EDID do either of the following:
Disconnect the outputs and repeat the steps listed in
Section
6.1
Press the input where the default EDID is to be stored to disconnect it from
the output
