48
VS-3232DN - Using the Test Video Card
9.4
Installing the Test Module
By default, the test module is installed in the configuration. If you uninstalled the
test module in the configuration, it must be reinstalled before it can be used. When
installing the test module, the number of configured inputs and outputs must be
increased by one. For example:
•
If your
VS-3232DN
has four inputs and eight outputs, you must configure the
VS-3232DN
as 5 x 9
•
If your
VS-3232DN
has 32 inputs and 32 outputs, you must configure the
VS-3232DN
as 33 x 33
To install the test module in the configuration:
1. Press ESC, ENT and LOCK together.
The following is displayed:
Configuration Device
2. Press ENT.
The following is displayed:
Test Board: 0 MaxInput:32 MaxOutput:32
where 0 indicates that the test module is not installed.
3. Using the numeric keys, press 1 to indicate that the test module is installed.
The TAKE button flashes.
4. Press TAKE.
5. Increase the number of configured inputs and outputs by one
(see
Section 8
).
6. Power cycle the device.
The test module is now installed and may be used.