![background image](http://html1.mh-extra.com/html/kramer/tp-900uhd/tp-900uhd_user-manual_2002184013.webp)
CONNECTING THE TP-900UHD
13
Always switch off the power to all devices before connecting them to your TP-900UHD.
After connecting your
TP-900UHD
, connect its power and then switch on the power to each
device.
1. Connect the output from an HDBaseT transmitter (for example, a
TP-582T
) to the HDBT IN RJ-45
connector.
2. Connect an HDMI video source to the HDMI IN connector.
3. Connect the HDMI OUT connector to an HDMI acceptor (for example, a display).
4. Connect the AUDIO OUT terminal block connector to a balanced stereo audio acceptor (for exam-
ple, an amplifi er).
5. Connect the S/PDIF connector to an acceptor of digital Audio
6. Connect an IR Sensor or Emitter to the IR 3.5mm mini jack.
7. Connect the Ethernet port to a PC
8. If required, connect the RS-232 3-pin connector to an RS-232 PC port or the Remote Controller.
9. Connect the 12V DC power adapter to the power socket and connect the adapter to the mains
electricity.
5.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
TP-900UHD
directly to the Ethernet port on your PC using a
cable (straight and cross are allowed) with RJ 45 connectors.
This type of connection is recommended for identifying the
TP-900UHD
with the factory
configured default IP address.
After connecting the
TP-900UHD
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device and click
Change settings
of this connection
.
The Local Area Connection Properties window for the selected network adapter appears as shown
in Figure 4.