OPERATING THE TP-900UHD
18
KRAMER ELECTRONICS, LTD.
3. Press ENTER and then using b or - navigate to parameter CONTRAST.
4. Press ENTER. The contrast value parameter changes to red.
5. Press the + button to increase the value (increase the contrast) or the – button to decrease the value
(decrease the contrast). The value ranges for contrast from 50% to 150% (100% - factory default
value).
6. Press and hold the + button or the – button to obtain auto decrement or increment of the parame-
ter.
7. Press and hold ENTER button together with the “-“ or with “+” to accelerate auto decrement or auto
increment of parameter values.
8. Press ENTER to accept and store the value (the parameter value fl ashes).
9. To return to one level menu hierarchy up, press MENU button.
6.3 The OSD Menu Structure
Submenu
Parameter
Values
Notes
SETUP
CONFIGURATION
LOAD SETUP #
1 – 16
Default 1
Load setup # into current active
setup
SAVE Current SETUP as
SETUP #
1 – 16
Default 1
Save Current Setup as Setup #
RESET Current Setup to
FACTORY Default
-
Reset Current Setup to Factory
Default
INPUT
CONFIGURATION
INPUT SWITCH MODE
Forced by HDMI/HDBT button
Auto when input signal loss
Auto to last connected input
Defi nes the behavior of input switch
engine when input signals or con-
nections change
INPUT HDMI HDCP
CAPABILITY
YES - default
NO
Assigns HDCP capability for HDMI
input
INPUT HDBT HDCP
CAPABILITY
YES - default
NO
Assigns HDCP capability for HDBT
input
Input SIGNAL LOSS
handle mode
Blue screen – default
Black screen
Freeze Last Picture
Turn off HDMI output
Sets the operation when input sig-
nal is not present
Turn off HDMI output about 20
seconds after input loss
EXTRA RANGE
DISABLED – default
ENABLED
Option ENABLED allows to extend
length of HDBT cable up to 180m
(only for resolutions not higher
than 1080p/60)
SELECT EDID
UHD 4K - default
1080P
UHD 4K EDID will allow a source to
output up to 4K signal, while 1080P
option will limit the source to FullHD
resolution
