Kramer KT-107S, User Manual, Page: 13 / 38

Kramer Electronics Ltd.
KT
‑
107S
– Mounting the KT
‑
107S 11
Installing KT
‑
107S on the Tabletop Mount
Before you begin, verify that the cable cover is removed.
To connect the cables and set the KT
‑
107S on the tabletop mount:
1. Connect the RJ-45 port on the tabletop mount to the PoE-enabled network.
2. Connect the power adapter to the Power 2-pin terminal block connector on the
tabletop mount and to the mains power.
3. Place the KT
‑
107S over the tabletop mount (the Touch Panel is magnetically held in
place), by first inserting the lower part of the Touch Panel then carefully laying the
KT
‑
107S in place.
4. Wait for the Home-page to load.
We recommend that you complete KT
‑
107S setup (see Setting up the KT
‑
107S , on page 17 )
before securing the KT
‑
107S to the tabletop mount.
Once setup is complete, carry on with the installation process.
5. Secure the KT
‑
107S to the tabletop mount using the two M2x4 screws (supplied) that
are inserted via the openings on the rear side of the tabletop mount.
6. Replace the rubber covers to hide the screws.
Figure 8: Connecting to the KT ‑ 107S Rear Panel