Kramer Electronics Ltd.
KT
‑
107S
– Mounting the KT
‑
107S
9
The cut-out dimensions in
Figure 5
are
not to scale
.
Kramer Electronics is not responsible for any damage caused to the table.
To drill the M5x60 screw hole in a table:
1. Measure the exact location on the surface of the table where you want to install the
KT
‑
107S
.
2. Drill a hole in the table and cut the cable pass-through opening with a saw according to
the dimensions shown in
Figure 5
(not to scale).
To cut the cable pass-through opening (if required):
1. Carefully measure the exact location of the cable pass-through opening.
Verify that the opening is correctly positioned in relation to the drilled M5x60 screw hole.
2. Cut out the cable pass-through opening.