Kramer KDS-EN2R, User Manual

Page: 14 / 35

KDS-EN2T, KDS-EN2R - Connecting the KDS-EN2T/KDS-EN2R 11
5 Connecting the KDS-EN2T/KDS-EN2R
You can set the
KDS-EN2T
/
KDS-EN2R
units in various configurations. For
example:
• A single transmitter/receiver setup (see Section 5.1
• A Multicasting setup (see
)
Section 5.2
• A video wall setup (see
)
Section 5.3
5.1 KDS-EN2T/KDS-EN2R Transmitter Receiver Setup
)
You can use the KDS-EN2T HDMI to IP Transmitter (see Section 4.1 ) and the
KDS-EN2R to configure an HDMI-to-IP Transmitter and Receiver system (see Figure
4 ).
Always switch off the power to each device before connecting it to your
KDS-EN2T / KDS-EN2R . After connecting your KDS-EN2T / KDS-EN2R ,
connect its power and then switch on the power to each device.
To connect the HDMI-to-IP transmitter and receiver system as shown in the example
in
Figure 4 , do the following:
1. On the KDS-EN2T , connect an HDMI source (for example, the HDMI output
from a media player) to the HDMI IN connector.
2. On the KDS-EN2R , connect the HDMI OUT connector to an HDMI acceptor
(for example, a projector).
3. Connect the LAN RJ-45 connector on the KDS-EN2T to the LAN RJ-45
connector on the KDS-EN2R using an Ethernet cable.
4. On both the KDS-EN2T and the KDS-EN2R , connect the 5V DC power
adapter to the power socket and connect the adapter to the mains electricity
(not shown in
Figure 4 ).
5. If required, connect a PC and/or controller to the RS-232 9-pin D-sub
Connector (see Section 5.4
i
) to control the HDMI acceptor, for example.