KPS 603550020, User Manual

Page: 86 / 245

86
-82-
TROUBLESHOOTING GUIDE
Start-up failure
Low battery Use battery after charging
Poor contact of battery
Remove battery, put it in
battery compartment again
and properly install the
battery
Plug of external battery is
not put in proper place Pull the plug and reinsert the
battery in proper place
Obvious deviation between
battery power indication and
actual power usage
Battery runs out
Replace it with a fully
charged battery
Battery life is expired Replace it with new battery
Unclear IR image
Lens have misted up or been
polluted &OHDQOHQVZLWKVSHFLDOL]HG
HTXLSPHQW
Unclear visible light image
Excessively dark
surrounding environment Take appropriate lighting
measures
There is vapor in front of
visible light or the visible light
is polluted Clean the front-end of
YLVLEOHOLJKWZLWKVSHFLDOL]HG
HTXLSPHQW
Inaccurate temperature
measurement
Relevant temperature
measurement parameters
are set incorrectly Change parameter setting
or restore the default
parameters directly
Non-uniformity correction
has not been implemented
for a long time
Set custom key as
compensation key in the
menu, press custom key,
and conduct non-uniformity
correction after shutter
sounds.
Temperature measurement
starts immediately after start-
up
To ensure temperature
measurement accuracy, we
recommend you to turn on
the thermal imager and then
wait for 5-10 minutes before
temperature measurement.
No calibration for a long time
To ensure accurate
temperature measurement
result, we recommend you
to send back the thermal
imager for calibration once a
year.