Page 8
An electrical box & romex connector are pre-installed on a removable panel on the right side of the fireplace.
A duplex receptacle and cover is included in the fireplace components packet. If wiring to the pre-installed
electrical box is desired, the wiring should be completed prior to permanently setting the insert in place and
connecting the vent system.
NOTE:
If this insert is being installed in the minimum opening dimensions, the wiring may need to be
completed after the fireplace insert is set in place.
NOTE:
Code approved line voltage wiring 14 gauge or better must be used when wiring this assembly. Refer to your
local electrical codes for specific requirements in your area.
WARNING: This appliance is equipped with a three-prong (grounding) plug for protection against shock hazard and should be
plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from
this plug.
Figure D-2
1. Remove the (2) screws securing the removable access panel (with electrical box & romex connector installed) from the
right side of the fireplace.
2. Insert 115V wiring (with ground) through the romex connector and wire to the duplex receptacle. Secure the duplex
receptacle to the electrical box.
3. Place the cover on the electrical box and secure with screw.
This appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Codes, CSA C22.1.
E. INSTALLING THE INSERT
IMPORTANT:
ALL STEPS IN SECTION ‘A) PREPARE THE EXISTING FIREPLACE’ MUST BE
COMPLETED BEFORE CONTINUING WITH THIS INSTALLATION.
1. INSTALL THE VENT SYSTEM
Summary of Contents for CAMBRIDGE CMB-31
Page 33: ...Page 31 Warranty Policy...
Page 34: ...Page 32 Warranty Policy...