kozy heat CAMBRIDGE CMB-31, Installation & Operating Manual

Page: 8 / 34

Page 6
Air Duct
A) Locate the spring-loaded latches securing the
glass assembly (under the firebox).
B) While holding onto the glass frame, pull the
latch handles out, then down to release from
the clips on the glass assembly.
C) Lift the glass assembly up off the tabs at the
top of the firebox.
D) Pull the bottom of the glass assembly out and
remove.
E) Set aside where it will not be broken.
F) Remove the log package from inside the
firebox and set aside for installation later in
this manual.
2. REMOVE THE AIR DUCT. Figure C-2.
A. Remove the air duct, located at the top of the insert, by sliding it back out of the channel.
Figure C-2
D. MODEL #CMB-31 ONLY: FAN INSTALLATION INSTRUCTIONS
This fireplace insert comes complete with a fan and temperature control switch assembly already installed. A speed control
/ receptacle assembly and (3) wire nuts are included in the fireplace components packet for wiring behind the lower air
passage. An electrical box and romex connector are pre-installed on a removable panel on the right side of the fireplace. If