Kostrzewa Platinum Bio ecoMAX860P3-O TOUCH (VG), User Manual

Page: 71 / 94

71
Platinum Bio ecoMAX 860P
User Manual – EN 03.17
Leader in pellet boilers
13. Installing controller
Panel mounting conditions:
1. panel,
2. vents for air circulation (note: vents must not reduce protection rating;
vents are not required if ambient temperature is not exceeded).
• Panel removal: Insert flat bars (2) into the slots to remove the panel (1)
from its enclosure. The flat bars release the catches holding the panel (1).
13.4 Installing main module
The main module is flush mounted. The mounting method must provide a
protection rating corresponding to the installation conditions and prevent
access to live components, e.g. terminals. Standard enclosure may be used. User
has access to the module front panel only. The module can also be installed in
the boiler components enclosing the entire module. The enclosure does not
provide dust and water protection. To ensure dust and water protection, use
suitable enclosure. The main module is mounted on a standard DIN TS35 rail.
Fix DIN rail to a rigid surface. Lift the catch (3) before mounting the module
on the rail (2). Release the catch (3) after positioning the module on the rail.
Make sure the device is fixed and cannot be removed without special tools.
For safety reasons, maintain safe distance between live terminals of the main
module and any conducting (metal components (at least 10 mm). Connecting
cables must be protected against pulling out and loosening or lead to avoid
excessive tension.