Kostrzewa Platinum Bio ecoMAX860P3-O TOUCH (VG), User Manual

Page: 70 / 94

70
Platinum Bio ecoMAX 860P
User Manual – EN 03.17
Leader in pellet boilers
11. Specifications | 12. Storage and transport... | 13. Installing controller
11. Specifications
Specifications
Power supply 230V~; 50Hz;
Controller power input 0,04 A
Maximum rated current 6 (6) A
Protection rating IP20
Ambient temperature 0...50 °C
Storage temperature 0...65 °C
Relative humidity 5 - 85% no condensation
CT4 temperature sensor measuring range 0...100 °C
CT6-P temperature sensor measuring range -35...40 °C
Temperature measurement accuracy 2 °C
Terminals mains screw terminals, diameter
0.75 mm2 to 1.5
mm2, tightening torque
0.4 Nm, stripping
length 6 mm
signal screw terminals, diameter
up to 0.75 mm2,
tightening torque 0.3 Nm,
stripping length 6 mm
Display (TOUCH) Kolorowy, graficzny
480x272 z panelem
dotykowym
External dimensions 210x115x60 mm
Weight 2 kg
Standards PN-EN 60730-2-9
PN-EN 60730-1
Software class A A
Protection rating For installation in Class
I devices
Pollution degree 2
to PN-EN 60730-1.
12. Storage and transport conditions
The controller must not be exposed to direct weather conditions, i.e. rain and
sunlight. Storage and transport temperature must not exceed -15…65 °C.
Do not expose to vibrations above those occurring in standard vehicle traffic
conditions.
13. Installing controller
13.1 Environmental conditions
Due to the fire hazard do not use the controller in the atmosphere of explosive
gases and liquids. Do not use the controller in places exposed to condensation
or water.
13.2 Installation requirements
The controller must be installed by a qualified and authorized fitter in
accordance with relevant standards and regulations. The manufacturer is not
responsible for any damage due to the failure to observe the instructions in this
User Manual. The controller is intended for flush mounting and must
not be used as a standalone device. Ambient temperature and installation
surface temperature shall not exceed 0-50˚C. The device includes two modules
(control panel and main module). Both modules are connected with a cable.
13.3 Installing control panel
The control panel is flush mounted in the mounting plate. Provide sufficient
thermal insulation between the boiler walls, the panel and the harness. Space
required for the installation of the control panel is shown below. Follow the
instructions and make a hole in the mounting plate as per the following
drawing.