14
Overview
Rear Panel
AUDIO OUT Section
Use these connectors to send the audio signal (sound) to a mixer,
a PA system, a set of powered monitors, or your hi-fi system.
LEFT, RIGHT
Use these line-level outputs to send the final stereo mix to an
external device. Connect either of them to output the signal in
mono. Adjust the output level with the MASTER VOLUME
knob.
Connect two mono cables to these outputs. Connect the other
end of the cables to a stereo channel of your mixer, two mono
channels, two powered monitors, or the CD, LINE IN or TAPE/
AUX input of your audio system. Don’t use the PHONO inputs
of your audio system!
PHONES
Connect a pair of headphones to this output. You can use head-
phones with an impedance of 16-200 Ohms (50 Ohms sug-
gested). Use a headphone splitter to connect more than one pair
of headphones.
AUDIO IN Section
Use these connectors to input sound from
another line-level device. The signal goes
directly to the final mix.
LEFT, RIGHT
Use these connectors to connect a line-level input source, such
as a keyboard/ synthesizer, a CD or MP3 player, or a mixer’s
(non-powered) output. Adjust the input level with the source’s
output volume.
Power
This is where you connect the Pa600 to the power line.
ACV cable connector
Plug the supplied AC cable into this con-
nector. To turn the instrument on or off,
use the STANDBY switch located on the
front panel.
Warning:
When the instrument is in standby mode, it is still con-
nected to the power line. Accessing the inside of the instrument can
be dangerous. To completely disconnect the instrument from the
power, unplug the power plug from the power socket on the wall.
Summary of Contents for PA 600
