Korg Digital Mixer ZERO8, Service Manual

Page: 19 / 42

5-2. SW Check
Ｆｉｇ 7 ＳＷ Check
Fig.7 is displayed in the LCD.
Operate the switches like Table 2.
B:Blue
R:Red
Table2 SW Check O:Orange
Switches which are checked. LED which lights. Color Notice
1-8chトtoggle switch"SOLO"→"OFF"→"CUT" - - "CUT"side is momentary.
1-8ch [CUE]ｘ2
[CUE] O→B Press twice each.
1-8ch [A][B] each switchｘ2
[A] or [B] O→B
Press[A]twice,Press[B] twice
EXT1 [CUE]
[CUE] O
EXT1 [CUE]
Meter L Peak LED R
EXT1 [CUE]
Meter R Peak LED R
EXT1 [CUE]
FireWire LED O
EXT2 [CUE]
[CUE] O
ZERO FX [CUE]
[CUE] B
[SET UP]
[SET UP] B
[BPM] [BPM]
B
[AUTO] [AUTO]
B
[TAP] [TAP]
B
[A] [A]
B
[B] [B]
B
[C] [C]
B
[D] [D]
B
1-8ROTARY ENCODER Push Switch
- - Press the knob.
[HOLD] [HOLD]
O
[CHANNEL] [CHANNEL]
O
[SEND] [SEND]
O
[MASTER] [MASTER]
O
6. LCD Check
Ｆｉｇ ８ ＬＣＤ Contrast Check
1. Confirm that all dots of LCD are lighting white.
2. Press the [MASTER].
Confirm that there is not uneven or lack of a dot.
3 Confirm that all dots of LCD are black.
Confirm that there is not a white dot or an alien substance, a scratch inside of the LCD.
4 Press the.[MASTER].
As Fig.8 "#" is displayed in the LCD and it repeats to change light and shade.
Confirm that this changing is normal.
5. Press the [MASTER] to proceed to the next.
Ｆｉｇ ９ After touched the top left.
７．Touch Panel Check
1. Touch the top left white square of the LCD. (Ｆｉｇ ９)
2. Touch the top right white square of the LCD.(Ｆｉｇ １０)
3.Touch the center white square of the LCD.
4. The white square follows to the point which you touch and move.
・Confirm that that the point you are touching and the white square are same. Fig.10 After touched bottom right.
・It follows to your moving finger.
・Confirm that when you touch the top left and the bottom right, the white square is displayed.
* When you want to repeat from 1, press the [HOLD].
5. Press the [MASTER] to proceed to the next.
Fig.11 Touch and move Check
KORG INC.
ZERO8 (X-5810) Check before Shipping
Revised
No.
Date 3／14 2007.4.25
QCI-5810 Page