52
JetPort 5208/5216 User’s Manual
Indirect HyperTerminal Connection
This method uses HyperTerminal to phone into the JETPORT 5208 /
JETPORT 5216 from a remote location.
Setup:
1. Set up your hardware configuration to match the diagram, below
:
JETPORT 5208 / JETPORT 5216
Serial Modem Cable
Ethernet to
Remote
Operator
Phone Line
Serial
Cable
Modem Modem
̝ ʳʳʳ
On the remote computer side, use a standard 9 pin serial modem cable
(pin 2 to pin 2; pin 3 to pin 3) to connect the computer to the modem.
̝ ʳʳʳ
On the JETPORT 5208 / JETPORT 5216 side, use Cat 5 cable and an
Note:
Be sure that the port you specify as the Console Port in the OOBC
dialog box (see p. 22) matches the port that you connect the modem
to. Change the setting, if necessary.
2. Create a HyperTerminal connection.
a) Start with Step 2 of the Direct HyperTerminal Setup section (p. 47).
b) For
Connect using:
in Step 4, select the type of modem connected to
your computer from the list. If your modem doesn't appear in the list,
select
Standard 28800bps Modem
.
c) Follow Steps 5-9 to complete the setup and create the connection icon.