9
Chapter 2. Hardware Setup
PC Installation
Refer to the Installation Diagram on p.10 (the numbers in the diagram
correspond to the numbers of the steps), as you do the following:
1. For each server or serial device, plug an
RJ45 to Serial cable
into its serial
port.
2. Plug the RJ-45 connector of the cable above to connect any available port
on the JETPORT 5208 / JETPORT 5216's rear panel to the adapter.
3. If you choose to install a serial modem for OOB operation (see Chapter 6),
use standard Ethernet cable to connect any available port on the JETPORT
5208 / JETPORT 5216's rear panel to a DTE to DCE serial Cable then
plug the cable into the modem's serial port.
Note:
This step is optional.
4. Plug a Ethernet cable to connects the JETPORT 5208 / JETPORT 5216 to
the network or the Internet into its LAN port.
5. Use the AC power cord provided with this package to connect the
JETPORT 5208/ JETPORT 5216's Power Socket to an AC power source.
After you connect all the cables, you can turn on the JETPORT 5208 /
JETPORT 5216.