3-2 Standby time for starter operation
This function adjust delay time until starter motor is operated when remote start,
cold start and time reservation start.
3-3 Crank time for the tach or noise sensing
(Only used by the install engineer)
This function adjust operation time of the starer motor when remote start by tach
or noise sensing.
3-4 Cold start temperature setting
When turn ON program menu 1-7, you can change the cold start temperature.
Default setting is -20 C.
3-5 Aux 1 output
(Optional : Only used by the install engineer)
In the default setting, Aux 1 will output in main for 1second when you operate
Aux 1 by transmitter. You can change the Aux 1 output time.
If you set to LCH (Continue), Aux 1 will be continuously output before you operate
Aux 1 by transmitter again.
3-6 Aux 2 output
(Optional : Only used by the install engineer)
In the default setting, Aux 2 will output in main for 1second when you operate
Aux 2 by transmitter. You can change the Aux 2 output time.
If you set to LCH (Continue), Aux 2 will be continuously output before you operate
Aux 2 by transmitter again.
20
20
Program Menu P-3 for Timing Function
Program Menu P-3 for Timing Function
3-1 Run time for remote start
This function adjust run time of the vehicle when remote start, cold start and time
reservation start.
2-8 Double door lock pulse
(Only used by the install engineer)
When turned ON, door lock output will output 2times whenever lock.
3-7 Turbo time setting
When you use the auto turbo timer program(P1-1), you can change the turbo
time. Default setting is 2minutes.
3-8 Arm delay time setting
When you operate arming(4page), you can change delay time of sensing(door,
trunk, hood) after door is locked. (Shock sensing is add 20 seconds to
delay time.)
Program Menu
Program Menu
