Code Learning
Code Learning
15
15
After 5 sec
Transmitter code learning
(The operation in the situation which the door is opened)
Transmitter code learning
(The operation in the situation which the door is opened)
The transmitter input is possible to each maximum 2pcs both one way and two
way transmitter.
"5 chirps"
"2 chirps"
Open the door
Turn from OFF to ON
the ignition key
over 8 times
Clear the all transmitter
code and it enters
new code input mode.
If you register new
transmitter, you will hear
2chirps, otherwise
the transmitter will be
valet mode with 3chirps.
This function is used when you lose transmitter or break down.
You can use this function though siren is
operated.
continually
This function
start in valet
mode.
3chirps
(Valet mode)
See 10page
Low battery indicator
Low battery indicator
Display
You must adjust current time again after battery interchange.
If the operation range of transmitter is shortened or the buzzer
sounding was lower than normal, please replace the battery to
new one.
The alkaline battery life is 2~3 months and exchange the battery
at once if the icon blinks.
RPM setup
RPM setup
Valet mode
ON
See 10page
M
+
Press the door and M button
for 2sec.
simultaneously
Idling
condition
is memory
Valet mode
OFF
See 10page
OFF
ACC
ON
Step 2. Set the valet mode.
Step 3. Press the door and M button simultaneously for 2seconds, then
the idling condition is memory in main control unit.
(This data is applied at remote start.)
Step 4. Cancel the valet mode.
RPM setup method
Engine ON
(Maintain idling condition)
If you install in tach pulse sensing wire (CN5 yellow),
you have to operate RPM setup.
Step 1. Engine ON and maintain idling condition. (600-700RPM)
(Only used by the install engineer)
OFF
ACC
ON
NOTICE
