Könner & Söhnen KS 600RTG, Manual

Page: 10 / 31

NEXT STEPS
NEXT STEPS
Gradually increase the depth of plowing when tilling the solid ground. Press on the steering wheel to
facilitate turning of the machine, transfer the weight of blade back when turning on the soil blade. (see
picture 38 in the Appendix). To adjust the forward speed, press the left handle grip. To move backwards
which facilitates the work with the tiller, use the right handle grip (see the picture below). Lower the front
wheel for device transportation (for models with a transport wheel). After work or during a break at work,
release the clutch and turn off the engine.
In order to prevent unintentional inclusion of the engine, disconnect the spark plug of the engine when
storaging device, transportation and all the works on cleaning and maintenance (such work is permitted
only with cooled engine).
The use, storage and maintenance of
Könner & Söhnen
®
tillers must be made according to this manual.
For all the damage and malfunctions, which were caused by mishandling of service, safety and working with
the machine manufacturer is not responsible.
REVERSE MOVEMENT
REVERSE MOVEMENT
Cultivator models are equipped with a reverse function for better maneuvering (except for model
KS 7HP-850A).
In order for the cutters or wheels to start reverse rotation, set the gearshift lever to the “-1” position (R) and
then press and hold down the clutch lever.
STOPPING THE ENGINE
STOPPING THE ENGINE
To eliminate the engine turn the switch to O (OFF) position. The engine switch is located on the control
panel handle.
THE MANUFACTURER IS NOT LIABLE FOR:
THE MANUFACTURER IS NOT LIABLE FOR:
- Using of lubricants, gasoline and motor oil, which are prohibited by supplier.
- Using the device for other purposes.
- Losses due to further use of faulty tiller parts.
- Technical changes of the device.
MAINTENANCE WORK
MAINTENANCE WORK
All works shown in “maintenance ” section should be done regularly. If you can not perform work, tiller
user should contact the service center to complete an application for technical works execution. In case of
losses due to injury, acquired as a result of outstanding maintenance, the manufacturer is not responsible.
Caution! Don’t use reverse mode for ground tilling!
ATTENTION - DANGEROUS
MAINTENANCE
7
1. Unscrew the locking nut near the handle or near the gearbox, make a few turns clockwise or
counterclockwise, depending on whether you need to loosen or tighten the cable.
2. After adjusting, tighten the retaining nuts, start the cultivator and check the clutch.
3. Repeat the adjustment operation if necessary.
KS 7HP-950S KS 7HP-950S – see picture 39 in the Appendix.
KS 9HP-1350G-3 KS 9HP-1350G-3 – see picture 40 in the Appendix.
konner-sohnen.com
| 9