Könner & Söhnen KS 600RTG, Manual

Page: 9 / 31

FUEL AND ENGINE OIL
FUEL AND ENGINE OIL
Only unleaded gasoline is recommended for the tiller.
Gasoline should be fresh. Use a funnel
(not supplied) for best device filling.
The tiller also can not run without oil, so fill it before the first launch. Set the device on a flat horizontal
surface, open the tank with oil and pour oil to the minimum mark and add fresh oil to the mark between
MIN and MAX. Use the probe to check the oil level. Oil level must be constantly monitored. Do not let excess
of oil and its lack. Information on used motor oil can be found in the technical characteristics of the tiller.
STARTING THE ENGINE
STARTING THE ENGINE
Before starting the engine, make sure the switch is in position I (ON) (see the pictures below). Turn the
rotary engine speed dial to MAX. Damper motor switch to position CHOKE. Grasp the starter handle and
slowly pull it to the emergence of resistance, then sharp fast motion pull starter all the way. Repeat the
operation until the engine starts. After starting the engine let the rope to entangle on trigger without
throwing the starter handle. Put the flaps in position RUN.
air damper
fuel valve
throttle governor
MAX
MIN
Engine switch
OFF ON
The engine switch is located
on the control panel handle.
starting
grip
Open Close
Open
Close
Сlutch lever
FORWARD MOVEMENT
FORWARD MOVEMENT
1. Set the gearshift lever to the “+1” or “+2” or “+3”) position.
2. Gently press the red fuse (near the clutch lever), press and hold
down the clutch lever ( see picture).
For model KS 7HP-1050G – see Fig. 5 on Section 7 in the Appendix..
CLUTCH ADJUSTMENT
CLUTCH ADJUSTMENT
If extraneous sounds are heard when pressing, or the clutch lever is
pressed hard, or the cultivator does not move when the clutch lever
is pressed. Most likely you need to adjust the tension of the clutch
cable. The cable must be adjusted with the cultivator switched off.
konner-sohnen.com
| 8