KONIG+NEURATH TALO.S Konferenz, Assembly Instructions Manual

Page: 39 / 48

36
Saved position (Memory)
Move the desk top to the required height, this position will be shown on
the display. Press the
S button. S will be shown on the display. Press
the required memory button (e.g.. 2 ). S will be shown on the display.
At this point the desk top position set will be saved under the selected
memory button. There is an audible double - click and after about 2 se -
conds the saved position will be displayed.
Note: to ensure safety the desk stops at a height of 720 mm. Press the
DOWN button again to reach its lowest position. In this range the memory
function is not active.
Retrieving a saved position
Press and hold the required memory button (e.g. 2 ).
The desk top moves until it reaches the position saved in the memory. Its
current position is shown on the display. Now release the memory button.
Reset (manual reset)
When getting started or in the case of malfunction (e.g.power cut):
As the control panel will automatically switch to energy save mode after
a few seconds, it has to be deactivated first. To do this, press the UP or
DOWN button briefly. Now press the UP and DOWN buttons at the same
time and hold down until the desk switches off automatically.
Successful reset is confirmed by an audible signal from the control panel.
Now release the buttons. The motorised height adjustment feature of this
desk can be used normally again.
Safety instructions:
During the reset process, the collision cut - out
is inactive! Beware of the risk of crushing. Please
ensure that there are no objects or persons in
the hazard area (the total potential lift and move
-
ment area for all components) and that they can -
not be pulled into the hazard area.