Konica Minolta Vivid 910, Instruction Manual

Page: 19 / 64

17
Connecting the VIVID 910 to a Computer
To operate the VIVID 910 from a computer using the Polygon Editing Tool, the VIVID 910 must be connected
to the computer with an standard SCSI cable.
WARNING
The computer must be operated correctly and safely according to its instruction manual.
M
emo
The standard SCSI cable has a 50-pin male plug (half-pitch, D-Sub) on both its ends.
For a description of the standard accessories, refer to page 6.
[Connecting Procedure]
1 Set the power switch of both VIVID 910 and
computer to OFF (“
”).
N
ote
If the AC power cord is connected to an AC outlet with the
power switch set to ON (“I”), damage to the VIVID 910 or
computer may result.
Before connecting them, always make sure that power is
turned OFF.
2
Plug the SCSI cable to a SCSI port of the VIVID
910.
3
Plug the other end of the SCSI cable to the
SCSI connector of the computer.
Connecting procedure is now complete
N
ote
Before turning ON the power to the computer, always turn
ON the power to the VIVID 910 and wait until it is ready
for operation (see page 13).
R
ef.
POWER
AC IN
SCSI
Vivid910-hard-E.book Page 17 Thursday, September 25, 2003 6:49 PM