Konica Minolta Magicolor 7300, Reference Manual

Page: 302 / 334

Introduction 294
Introduction
The PJL commands supported by your printer are identified and described in
this chapter. PJL commands are identified first and then followed by the
definition of environmental variables.
The commands and variables in the following sections are listed by name and
in alphabetical order.
Commands
Command
DEFAULT
Syntax
@PJL DEFAULT [LPARM : personality
|
IPARM :
port ] variable = value [<CR>]<LF>
Description This command can be used to change the User Default
Settings of the printer. DEFAULT is used with
environmental variables to set the user default value of a
printer parameter. See the “Environmental Variables” on
page 301 for a listing of variables that are available for your
printer.
Notes The User Default Settings are also configurable from the
printer’s control panel. Using the DEFAULT command does
not affect the Factory Default Settings of the printer.
Changes to the Default Settings are not activated until a
RESET command has been executed. See the RESET
command on page 299 for more information.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500