Konica Minolta magicolor 1600W, Service Manual

Page: 53 / 216

5. Firmware upgrade Field Service V er. 1.0 Nov. 200 8
16
magicolor 1600W magicolor 1650EN
Maintenance
5.2 For magicolor 1650EN
5.2.1 Controller firmware upgrading
NOTE
• Make sure that the printer driver has been installed in the PC.
• Before updating the firmware, print Configuration Page to confirm the current
Controller Firmware Version.
See P.65
A. USB connections
1. Connect the machine and PC using the USB cable.
2. Copy the firmware data (system3.img) to any directory on the PC.
3. Holding down the Menu Select key and key on the control panel at the same time,
turn ON the printer’s power switch.
4. To select YES for each of the items shown below, use the or key. Then press
the Menu Select key.
• [UPDATE PRINTER]: YES
• [REPLACE CODE]: YES
• [REPLACE ALL FONT]: YES
• [REPLACE SYS FONT]: YES
• [UPDATE NOW]: YES
5. Make sure that the message “PRINTER UPDATE SEND DATA NOW” appears on the
control panel.
6. Start the command prompt and go to the directory in which the firmware data is stored.
7. Type “copy/b system.img \\xxxxx\yyyyy:” and then press the Enter key
(xxxxx is the hostname) (yyyyy is the sharename)
8. Check the message on the control panel and make sure that [IDLE] is displayed.
NOTE
• Do not turn the printer’s power switch OFF while the firmware is upgrading.
9. Print a Configuration Page and check the firmware version to verify the upgrade.
See P.65
A034F2E519DA