E-9
27. <110-127 V regions>
Plug the copier and image controller power
cords into an outlet.
<220-240 V regions>
Connect the image controller power cord to the
copier. Plug the copier power cord into an outlet.
IV. Specifying the copier settings
From the copier, specify the necessary settings for
using the image controller.
<Image Controller Settings>
1. Turn on the copier.
2. Display the Service Mode screen.
(For details on displaying the screen, refer to the
Service Manual.)
3. Touch [System 2].
4. Touch [Image Controller Setting].
5. Touch [Controller 1].
6. Touch [END].
7. Touch [Exit].
8. Turn the copier off, then on again. (If the copier
has not been turned off, the setting changes are
not applied.)
V. Connecting the copier and image con-
troller to a network
The network functions of the copier can be used
even when the image controller is installed.
There are two ways of connecting to a network from
this copier. When connection b is used, some func-
tions are limited.
Note:
• Use a network cable (Category 5E or later rec-
ommended) to connect to a computer.
• For details of the connection method, see step
18 and subsequent steps in “III. Installation pro-
cedures.”
a: Connecting the copier and image controller
with separate LAN cables
• With this connection method, the network func-
tions of the copier are not impaired, and the
image controller functions are added.
• When this connection is made, the KM Box func-
tion is unavailable.
The KM Box function is described at the end of
this manual.
• The IP address settings for the copier and image
controller are specified separately.
• In order to use the network functions of the
copier, the network settings on the copier must be
specified according to the functions to be used.
1. Use a network cable to connect the LAN port of
the copier to the hub (LAN).
2. Use a network cable to connect port 1 of the
image controller to the hub (LAN).
Note:
Depending on the connection method, the image
controller TCP/IP settings are different. For details,
refer to 9 in “VI. Specifying basic image controller
settings (IP address)”.
A4MGIXE072DA
<220-240 V regions>
A4MGIXC037DA
Port 1
Port 2
