E-6
21. Route the network cable through the harness
guides and three wire saddles.
Note:
Leave an appropriate amount of slack in the por-
tion of the cable between the plug and the top har-
ness guide in a manner which does not interfere
with the opening and closing of the cover.
22. Route the cable through the notch cut in step 19
and attach the rear right cover. (Two screws)
23. Insert the two image controller tabs into the
holes on the copier cover.
24. Screw the image controller to the cover. (Three
supplied screws A and one supplied screw B)
Note:
Screw the screws at the bottom and side first.
25. Connect the image transmission cable to the
image controller.
Note:
Take care not to excessively bend the image
transmission cable.
26. Route the image transmission cable through the
two cable clamps of the image controller.
A4MGIXC023DA
Leave an appropriate
amount of slack.
A161IXC058DA
A4MGIXC024DA
Tab
A4MGIXC025DA
Screw A
Screw A
Screw B
A4MGIXC071DA
A4MGIXC027DA
