Konica Minolta FK-101, Service Manual

Page: 131 / 225

7-15
INFO 0x Bit Assignment
) B S M - B S L ( s t i B
3 - 0 1 1 1 1
1 1 - 4 0 1 0 0 1 1 1 0
2 1 0 / 1
3 1 0 / 1
4 1 0 / 1
5 1 0 / 1
6 1 0 / 1
7 1 0 / 1
8 1 0 / 1
9 1 0 / 1
0 2 0 / 1
3 2 - 1 2 0 to 5
4 2 0 / 1
5 2 0 / 1
7 2 - 6 2 0 to 3
8 2 0 / 1
4 4 - 9 2
8 4 - 5 4 1 1 1 1
Value Meaning
Fill Bits
Bit string for frame synchronization
2743 symbol / sec support
2800 symbol / sec support
3429 symbol / sec support
Ability to transmit at low carrier frequency at 3000 symbol / sec
Ability to transmit at high carrier frequency at 3000 symbol / sec
Ability to transmit at low carrier frequency at 3200 symbol / sec
Ability to transmit at high carrier frequency at 3200 symbol / sec
3429 symbol / sec transmission
Ability to lower the transmission level than a preset value
Maximum tolerance of symbol rates between transmission and reception
0; 2400, 1:2743, 2:2800, 3:3000, 4:3200, 5:3429 symbol/sec
1=INFO 0 is sent from the CME modem
1664 signal point (33.6K) ability
Clock source transmission 0: internal, 1: external, 2: synchronous to the reception clock
3: Reserved
1=Correct INFO 0 frame is received during error recovery
CRC
Fill Bits
INFO h Bit Assignment
) B S M - B S L ( s t i B
3 - 0 1 1 1 1
1 1 - 4 0 1 0 0 1 1 1 0
4 1 - 2 1 0 to 7
1 2 - 5 1 0 to 7 2 1
2 2 0 / 1
6 2 - 3 2 0 / 1
9 2 - 7 2 0 / 1
0 3 0 / 1
6 4 - 1 3
0 5 - 7 4 1 1 1 1
Value
Meaning
Fill Bits
Bit string for frame synchronization (transmitted from the left side)
Output reduction width demanded by the reception modem (dB)
When *the modem on the transmitting side can not reduce output*
at INFO 0, the value is set to 0.
The length of TRN which the modem of the transmitting side send in the Phase 3 (x35ms)
High carrier is user for data mode Tx.
Pre-emphasis filer index No.which is used for data transmission
Symbol rate of data transmission 0: 2400 ***5: 3429 (symbol / sec)
Selection of parameters used for TRN. 4 points / 16 points
CRC
Fill Bits