Konica Minolta 7416MFG, Advanced Information

Page: 241 / 285

8 When a Message Appears
8-26 7416MFG
The printed output has dark
specks or spots.
The printed output has lines.
The Original Glass surface is
dirty. Wipe the Original Glass
clean with a soft, dry cloth.
The Original Pad is dirty. Wipe the Original Pad clean
with a soft cloth dampened
with neutral detergent.
The original is highly
transparent. Place a blank sheet of paper
over the original.
The original is 2-sided. If a thin double-sided
document is being printed,
the information on the back
side may be reproduced in
the print. Press the [ ] key
and select a lighter print
density.
Something is sticking to the
Original Glass (when the
Auto Document Feeder is
used). Wipe the Original Glass
clean with a soft, dry cloth.
The Drum Cartridge has
reached the end of its
service life. Contact your service
representative.
The printed output on the
copy is not aligned properly. The original is not placed in
the correct position. Place the original correctly
on the Original Glass against
the Original Scales.
Or, load it in the Auto
Document Feeder correctly
along the Document Guide
Plates.
The original may not be
suitable for use in the Auto
Document Feeder. Raise the Auto Document
Feeder and place the original
on the Original Glass
correctly against the Original
Scales.
The paper guides are not
pressed up against the paper
stack in the tray. Slide the paper guides
against the edges of the
paper stack.
The paper has an excessive
curl. Smooth out curls in the
paper and reload the paper
stack in the tray.
The printed page is curled. The paper that was used
curls easily (as with recycled
paper). Remove the paper from the
paper tray, turn it over, and
then load it again.
Change the paper.
Symptom Possible Cause Action
Ö