Konica Minolta 0862, Operation Manual, Page: 164 / 200

Ch.6 Troubleshooting
< 162 >
REGIUS Console CS-3 OPERATION MANUAL Ver. 1.10 2005.2
Error No.
0513
0514
0531
0541
0542
0543
0551
0561
0562
0571
0572
0573
0574
0575
0581
0582
0583
0584
0585
0586
0587
0588
0589
058A
058B
0591
0592
0593
0594
0595
0596
0597
0701
0702
0703
0704
0711
0712
0713
0714
0802
0803
0804
0811
0812
0813
0814
Error Message Remedy
Concerning the Upright Reader
Servo motor alarms(excess current)
Servo motor alarms(overflow)
Sub-scanning moving down timeout
No-shut-off A error of erase lamp
No-shut-off B error of erase lamp
No-shut-off AB error of erase lamp
Polygon PLL lock error
HSync is active
The polygon index is active
No HSync is detected
No enough HSync
Too much HSync
No polygon index is detected
Too many polygon indexes
LD excess current 2 error
No LD Strong HSync is detected
LD excess current 1 error
No LD Strong HSync is detected. (1 error)
No LD weak HSync is detected. (2 error)
No HSync is detected. (2 error)
No LD weak HSync is detected. (3 error)
No HSync is detected. (3 error)
15V power supply abnormal error
No LD weak HSync is detected. (1 error)
No HSync is detected. (1 error)
Polygon PLL lock error before gain offset
Communications abnormality for correcting CPU during gain offset
HSync error during gain offset
Out-of-target(Hi) error
Out-of-target(Lo) error
Gain calculating error
Offset calculating error
No-illuminated intermittent erase lamp
No-shut-off A error of intermittent erase lamp
No-shut-off B error of intermittent erase lamp
No-shut-off AB error of intermittent erase lamp
No-illuminated intermittent erase lamp
No-shut-off A error of intermittent erase lamp
No-shut-off B error of intermittent erase lamp
No-shut-off AB error of intermittent erase lamp
No-shut-off A error of intermittent erase lamp
No-shut-off B error of intermittent erase lamp
No-shut-off AB error of intermittent erase lamp
Upper&lower sensor simultaneous detection error
Lower sensor detection error
Servomotor alarms(overheated driver)
Servo motor alarms(excess current)
Restart the CS-3 and Upright Reader.
Contact your Service Representative.
The same error occurs repeatedly.