10
Inclination of the cleaner:
In case the cleaner should be used for pre cleaning, it
is advised to adjust the inclination to:
•
approx. 6° on KDC4000
•
approx. 9° on KDC8000
The inclination has an influence on the flow rate and
the layer thickness on the screens, and thus also on
the cleaning performance.
At an inclination of approx. 4° the inner screen is hori
-
zontal at the bottom. The inclination must there-fore
never be less than 4° as the inner screen should either
be horizontal or incline towards the outlet end.
Normally, there is no need to set the cleaner with an
inclination greater than:
•
approx. 7° on the KDC4000
•
approx. 12° on the KDC8000
When installing, it is therefore important to take into ac-
count, that the inclination of the machine can be adjust-
ed. In particular, it must be taken into account that the
inlet and outlet connections can be adjusted to changes
in inclination.
Mount for example a flexible steel hose on the inlet and
blower outlet (Kongskilde order number 122 050 156) -
see also section "Accessories".
For high-capacity pre-cleaning, it is usually necessary
to adjust the inclination angle from:
•
approx 4,5° - 7° on KDC4000
•
approx. 8° - 12° on KDC8000
Use the protractor on the side of the cleaner to
adjust the inclination.
Set the arrow to the desired number of degrees. Now
raise the inlet end of the cleaner, until the spirit level
indicates that the arrow is horizontal, by:
• KDC4000 without lifting arrangement
- lift the
cleaner, adjust the height of the legs, and lower the
cleaner so that it rests on the legs
• KDC4000 with lifting arrangement and KDC8000
with lifting arrangement
- turn the crank at the end
of the cleaner.
Crank for adjustment of inclination
