4
2
3
5
Instruction manual SMV 10 600B – 60 1500B Publ. no. 6196.082 1117, Version 02
73
Service and maintenance
Cleaning/replacement of main filter
Clean or replace the filter if the indicator for low pressure is
switched on.
• Open all clips (1) and remove the cover (2).
• Remove any dust that has collected in the cover and dry it with
a damp cloth.
• Carefully remove the filter element (5).
• Clean the inside of the filter cover (3) with a damp cloth.
• Shine with a light inside the filter element and check from the
outside that there are no holes or cracks in the filter paper.
• Clean the filter element (5) using dry pressurised air, max. 1 bar,
from the inside until no more dust comes out.
• Mark the filter element when it has been cleaned.
NOTE
This is a dry filter element and it must not be cleaned with wet fluids.
NOTE
Consider the surrounding environment when the work is being performed.
Dispose of the filter element:
• if it has been cleaned four times
• if it is damaged
• after about 1,000 operating hours
• after no more than 12 months use
Note every service on the filter element.
• Fit the filter in the reverse order.
• Reset the indicator by pushing the button under the unit.
Safety cartridge
NOTE
Never clean the safety cartridge.
Do not remove the safety cartridge unnecessarily.
• The safety cartridge (6) is normally replaced after intervals as per
the section in the inspection and maintenance schedule, or if the
main filter has been damaged.
• Disassemble the filter insert as per above.
• Fit a new safety cartridge.
