Instruction manual SMV 10 600B – 60 1500B Publ. no. 6196.082 1117, Version 02
71
Service and maintenance
Replace the fuel pre-filter (2) as follows.
• Place a container under the fuel pre-filter (1) to collect any fuel
leaks.
• Remove the hose (4) from the sensor for the water separator.
• Remove the filter from the filter holder.
• Remove the bottom section of the water separator from the filter.
• Clean the bottom part of the water separator with a soft cloth.
• Ensure that the drain hole in the bottom part is not blocked.
• Fit a new seal in the bottom part and lubricate it with diesel.
Refit the bottom part of the filter.
• Lubricate the seal with diesel. Fit the new filter to the filter
holder by hand until the seal comes into contact with the
holder. Then turn the fuel pre-filter another 1/2 turn, not more.
• Replace the hose (4).
• If necessary, bleed the fuel system.
Empty the fuel pre-filter (2) of water as follows.
• Place a container under the fuel pre-filter to collect any fuel leaks.
• Open the drain tap (3) to the fuel pre-filter.
• Tighten the drain tap when fuel without water starts to drain out.
Bleeding the fuel system
The fuel system will only need bleeding if it has been run completely
dry. Bleeding is done with the hand pump on the fuel filter holder.
