13
UAB KOMFOVENT we reserve the right to make changes without prior notice
RHP STANDARD_21-04
2. UNIT TRANSPORTATION
Equipment must be transported and stored in the original packaging. During transportation, equipment must be prop-
erly secured and further protected against possible mechanical damage, rain or snow.
Forklift truck or crane can be used for loading or unloading. For the crane operation, special lashes or ropes must be
used to securing them in the designated areas. Ensure that lifting lashes or ropes do not crush or otherwise damage the
housing of the unit. We recommend using special belt supports. When lifting and transporting the equipment with a forklift,
the forks must be long enough to prevent the unit from being overturned or mechanically damaging its bottom side. Air
handling units are heavy, therefore, be careful during lifting, moving or transportation. Use personal protective equipment.
Even small units should be transported on a forklift, a trolley or carried by multiple persons.
L
≥L
Max. 0,3 m
Fig. 7.
Examples of transportation by crane, forklift and trolley
After delivery of the air handling unit, carefully inspect its packaging for damage. If mechanical or other damage is visible
(e.g., wet cardboard packaging), notify the carrier immediately. If the damage is significant, do not accept the unit. Inform
the selling company or the representative of UAB KOMFOVENT within three business days about any damage detected dur-
ing delivery.
1
Units should be stored in a clean, dry room at a temperature of 0-40 °C. When selecting a storage location, make sure the
unit is not accidentally damaged, that other heavy objects are not loaded on top and dust or moisture does not get inside
the unit.
•
Air handling units are heavy, therefore care must be taken during lifting, carrying or moving
operations. Use personal protection equipment, do not stand under a suspended unit or a part
thereof.
•
Only an employee qualified to operate a forklift truck or crane and familiar with the principles of
cargo lifting and safety requirements, must perform unloading or lifting operations.
•
It must be ensured that the casing is not crushed or otherwise damaged by straps or ropes dur-
ing lifting operations. Use of special supporting structures (traverses) is recommended.
•
When lifting the unit or section thereof, note that their center of gravity may differ from the geo-
metric center of the load.
•
Mounting of separate air handling units in stacks is not allowed unless it’s construction design is
intended for such installation.
•
Before installation AHU must be stored in clean and dry premises in their original packaging. If
the unit is installed but not yet in use, all connection openings must be tightly closed and the
unit must be additionally protected against environmental influences (dust, rain, cold, etc.).
1
UAB KOMFOVENT is not responsible for losses caused by the carrier during transportation and unloading.
Summary of Contents for 1300 U
Page 1: ...INSTALLATION MANUAL EN RHP Standard ...
Page 2: ......
