Komatsu D65EXi-18, Operation & Maintenance Manual

Page: 66 / 184

Enable “Smooth Start” and select “Cutting & Carry”.
1.
Start the blade automatic control at position (A) apart from piling position (U).
The machine automatically start the dozing.
2.
After carrying the soil to piling point (B), drive the machine in reverse.
(T) Design surface
REMARK
• If some place higher than the design surface is left at 1 time dozing, travel on that place several times so
that such place can be built as designed.
• If the soil in front of the blade disappears and no load to the blade in the middle of carrying the soil, drive
the machine in reverse once and get the load to the blade again.
• When the design surface is deep, offset the design surface upward and cut the ground by each 150 to
300 mm in steps, you can operate smoother and more stable.
• For the type of soil which requires frequent gear shifting, the following modes are recommended.
• Forward 1st (F1) of automatic gear shift mode
• Forward 1st (F1) of manual gear shift mode
• Forward 2nd (F2) of manual gear shift mode and Auto Shift Down is ON
Set the blade load mode to “Heavy” to make the operation stable.
METHOD FOR SCRAPING SOILS IN SHORT DISTANCE
In this method, carrying distance is short and operation is efficient.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-52