Komatsu D65EXi-18, Operation & Maintenance Manual

Page: 44 / 184

10. Lower the blade to match the either end of blade at right or
left side with the base point.
Stop the blade just before it touches to the ground and the
base point, and do not lower the blade to the ground.
REMARK
The setting place of the base point should be determined
in advance so that the machine is leveled with standard
posture.
The standard posture denotes that the blade edge is the
same height of the ground where the track contacts.
11. Check that “elevation control key” (1) and “slope control
key” (2) are green and the machine direction on the control
box screen is the same as the actual machine direction.
When “Heading Initializing” is displayed, retry from step 8.
Even if the machine is out of the design surface and “Out
of design area” is displayed, it is not a trouble.
12. On the control box screen, press “iB logo key” and display
the main menu.
13. On “Tools” menu, press “Position check...” and select.
14. On “Position Check” screen, select the position of blade
matched with the base point.
• When matched with the left blade edge: “Blade: Left”
• When matched with the right blade edge: “Blade:
Right”
15. Press “Measure...”.
The screen shown on the right is displayed.
When the bar at the bottom of the screen reaches the right
end, screen returns to “Position Check” screen.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-30