Kolver EDU 2AE/TOP/NT, Manual

Page: 19 / 30

Page 19

CN2 CONNECTOR – 14 pins
All of the following pins are input: make a contact with pin 14 to activate them.
PIN NAME FUNCTION
1 NOT USED
2 MISSING PIECE
If enabled it stops the motor, enables the error signal and “ Error missing
piece ” is displayed on the status bar.
3 OK EXT
If enabled (see point 4: OK-ESC commands, in the option menu), remote
OK key function.
4 ESC EXT
If enabled (see point 4: OK-ESC, in the option menu), ESC key function to
reser remote errors.
5 RESET EXT
If enabled (see point 4: OK-ESC commands, in the option menu), it resets
program or sequence according to the preset function (see point 5: Reset, in
the option menu)
6 INPUT 8
Switch – selection of program 8
7 INPUT 7
Switch – selection of program 7
8 INPUT 6
Switch – selection of program 6
9 INPUT 5
Switch – selection of program 5
10 INPUT 4
Switch – selection of program 4
11 INPUT 3
Switch – selection of program 3
12 INPUT 2
Switch – selection of program 2
13 INPUT 1
Switch – selection of program 1
14 GND
Common to every input. Signals have to be enabled making contact between
the desired signal and this pin (common 0VDC) .