Kohler ZCB-6, Installation Instructions Manual

Page: 8 / 34

8 TT-1684 3/16
Figure 18
Transformers and Terminal Block
Removed from Lower Panel but Not
Disconnected
15. Remove the metal cover over the optional
communication module, if present. See Figure 19.
Figure 19 Remove Cover Screws
16. Remove the controller and the lower panel from the
lower door of the enclosure. See Figure 20.
Figure 20 Controller and Lower Panel Removed
Mounting Plate and Cover Plate
Note: Refer to the notes in Figure 22 before installing
the mounting plate and switch cover plate. Some
door studs may need to be cut off and some
mounting holes enlarged in the field, depending
on the specific application.
17. Install conversion kit mounting plate GM99317.
Use seven lock washers X-22-7 and seven nuts
X-6210-4 to install the mounting plate as shown in
Figure 21 and Figure 22. Install three flat washers
X-25-122 with three nuts X-6210-2 as shown.
18. Install DIN rail GM47488 using two nuts X-6210-4.
Install panel retainer GM70051. See Figure 21.
Figure 21 Mounting Plate Installation