16
TT-1684 3/16
34. Disconnect plug P8 from the upper board. See
Figure 42.
Figure 42
Disconnect Plug P8
35. Cut lead 33 (pin location: 15 on plug P8). See
Figure 43. Lead 33 will be connected to the MPAC
1500 controller later in this procedure.
Figure 43
Cut Lead 33 at Pin 15 on Plug P8
36. Connect the conversion kit wire harness
(GM77518 or GM77826) connector P8 to plug P8
that was disconnected from the upper board in the
previous step. See Figure 44.
Figure 44
Connect Conversion Kit Wire Harness
Connector P8 to Plug P8
37. Disconnect plug P9 from the upper board. See
Figure 45. Cut the cable ties to separate the
harness from the other wiring and discard the P9
harness. (The other end of this harness was
disconnected in step 7.)
Disconnect
P9
P8 connected
to conversion
kit harness.
Figure 45
Disconnect P9
Summary of Contents for ZCB-6
Page 9: ...TT 1684 3 16 9 Figure 22 Conversion Kit Assembly...
Page 14: ...14 TT 1684 3 16 GM77826 Figure 37 Conversion Kit Harness GM77826 for Model ZCB 6...
Page 21: ...TT 1684 3 16 21 Figure 55 Current Sensing Kit Wiring Diagram GM47803...
Page 34: ...TT 1684 3 16 34 This page intentionally left blank...