12
TT-1684 3/16
Decals
Note:
The photos on this page do not show the latest
controller design. See Figure 25.
23. Remove the existing switch decal, if necessary.
Verify that the surface is clean and dry, and affix
conversion kit decal GM67498 over the old decal
on the outside of the bottom door. See Figure 30
and Figure 31.
REMOVE DECAL,
IF NECESSARY
Figure 30
Before Decal Installation
Figure 31
After Decal Installation
Disconnect Switch
24. Re-install the (AUTO/INHIBIT) disconnect switch
through the conversion kit mounting plate. See
Figure 32 and Figure 33.
Figure 32
Disconnect Switch Re-Installed
Figure 33
Disconnect Switch (inside door)
25. Connect the AUTO/INHIBIT disconnect switch to
the existing plug that was disconnected in step 9.
See Figure 34.
Figure 34
AUTO/INHIBIT Switch Connection
Summary of Contents for ZCB-6
Page 9: ...TT 1684 3 16 9 Figure 22 Conversion Kit Assembly...
Page 14: ...14 TT 1684 3 16 GM77826 Figure 37 Conversion Kit Harness GM77826 for Model ZCB 6...
Page 21: ...TT 1684 3 16 21 Figure 55 Current Sensing Kit Wiring Diagram GM47803...
Page 34: ...TT 1684 3 16 34 This page intentionally left blank...