Kohler ZCB-6, Installation Instructions Manual

Page: 1 / 34

TT-1684 3/16
INSTALLATION INSTRUCTIONS
Original Issue Date: 3/16
Model: ZCM-6 and ZCB-6 Programmed-Transition Bypass/Isolation Switches
Market: ATS
Subject: Controller Conversion Kits GM99316-S4 and -S5
Introduction
The conversion kit allows the replacement of the M340+
controller with a Decision-Maker r MPAC 1500 controller
on model ZCM-6 and ZCB-6 programmed-transition
bypass/ isolation switches.
See Figure 1 for an illustration of the installed kit. See
Figure 2 for controller identification, if necessary.
Note: The optional accessory board (I/O) assembly
shown in the figures is available separately.
GM99316
2
1. MPAC 1500 controller assembly
2. Optional accessory board (I/O) assembly
1
Figure 1 Decision-Maker
r
MPAC 1500 Controller
Conversion Kit, Installed
Tools and Materials Required:
D
Phillips
r
screwdriver
D
Small flat tip screwdriver
D
Wire cutter
D
7/16 nut driver
D
11/32 nut driver
D
5/16 nut driver
Read the entire installation procedure and compare the
kit parts with the parts list in this publication before
beginning installation. Refer to the wiring diagrams at
the end of this publication as needed during the
installation. Perform the steps in the order shown.
Decision-Maker
r
MPAC 1500 Controller
TT1684
M340+ Controller
Figure 2 Controller Identification