3
2.6
Secure the Backplate to the wall using
the Securing Screws (supplied).
Caution!
It is essential at this point
that the supply pipework is thoroughly
flushed through before connection to
the thermostatic mixer. Failure to do so
may result in product malfunction.
2.7
Fit the compression Nuts and olives
onto the pipework.
2.8
align the thermostatic mixer with the
pipework and fit onto the Backplate.
2.9
tighten the compression Nuts onto
the thermostatic mixer with a suitable
Spanner.
Caution!
take care not to damage
the chrome surfaces.
2.10
tighten the Grubscrew to secure
the thermostatic mixer to the
Backplate.
2.11
Fit the Shower Fittings, refer to your
Fittings Installation and user Guide
for Instructions.
note!
For high pressure systems,
a litre/minute flow regulator
(supplied) can be fitted under the
hose washer.
2.12
turn on the hot and cold water
supplies and check for leaks.
2.13
the maximum temperature of the
thermostatic mixer is factory set to
approximately 43°c. If adjustment
is required, refer to section:
‘Commissioning’
.
Flow regulator
(for high pressure
systems)
Grubscrew
