2. Rising or Falling supplies
2.1
loosen the Grubscrew on each elbow
using the .5 mm hexagon Key
(supplied) and rotate the elbow 90° as
required. retighten the Grubscrews.
2.2
use the Installation template to mark
the positions of the fixing holes for the
Backplate.
note!
allow a minimum of 50 mm
either side of the thermostatic mixer,
to allow access to the hot and cold
Inlet Filters for servicing.
2.3
For solid walls drill the Backplate
holes with a 6 mm diameter drill
and insert the Wall Plugs (supplied).
For other types of wall structure
alternative fixing may be required (not
supplied).
2.4
Fit the supply pipework, 35 mm
from the finished wall surface
t o t h e c e n t r e o f t h e p i p e s
(hot - left, cold - right).
note!
use the installation template to
set the distance from the wall (35 mm
centres / 53 mm apart).
note!
If the connections are reversed,
complete the installation then refer to
section:
‘Reversed Inlet supplies’
before commissioning.
2.5
loosen the Grubscrew with the
.5 mm hexagon Key (supplied)
and remove the Backplate from the
thermostatic mixer.
53 mm
Wall
Plugs
35 mm
40 mm
153 mm
Shower Control
Backplate Fixing Points
(Ø6 mm)
Bend tabs inward
s
Use as a support for the spirit level
Bend tabs inward
s
Use as a support for the spirit level
Hot Supply Inlet
(Ø15 mm)
Make sure that supply pipes are thoroughly flushed through
before connection to the shower control
Cold Supply Inlet
(Ø15 mm)
53 mm
50 mm
50 mm
40 mm
35 mm
35 mm
