17
1490289-W2-A
‘Snap Off’
section for
rear entry
Terminal
Block
(LH)
Replacing an Existing Electric Shower
This electric shower can replace showers of approximate size and shape.
Terminal Blocks are provided on both the left and right for convenience when
replacing a shower.
If the water entry point is on the right hand side of the shower then you will need to
alter the incoming pipework as shown below. The Mira Inlet Pipe Accessory can be
used to simplify this process. Refer to section:
‘ACCESSORIES’
.
Existing
pipework
locations
‘Snap Off’ case sections are provided for
ease of installation when using existing right
side, rear entry pipework.
Terminal
Block
(RH)
Warning!
Isolate the electrical and water
supplies.
From the new
shower, remove
t h e t h r e e
s c r e w s t h a t
hold the cover
on then remove
the cover.
Disconnect and remove the old
shower from the wall.
Cover
Screw
Screws
Place the shower on the wall where the previous shower was installed and
mark the positions of the
three
fixing holes.
Note:
Ensure that there are sufficient lengths of supply pipe and electrical
cable to reach the connection points.
Remove the shower and drill three holes to suit the fixing screws and wall
plugs.
Caution!
Do not drill into cables or pipes in the wall.
1
2
3
4
Summary of Contents for Mira Jump 10.5 kW
Page 2: ...2 1490289 W2 A ...
Page 30: ...30 1490289 W2 A Notes ...
Page 31: ...31 1490289 W2 A Notes ...
