18
1490289-W2-A
Thoroughly flush the supply pipe.
Secure the shower to the wall with fixing screws
and wall plugs (supplied) or appropriate wall fixings
for your installation.
Connect the inlet supply pipe to the inlet connector
using a push fit elbow or an elbow with compression
nuts and olives.
Turn on the water supply and check connection
for leaks.
Use the terminal block location that is most
appropriate for your installation i.e. If the electric
supply is on the right hand side then use the right
hand terminal block.
Strip back sufficient outer cable insulation to enable
routing to the terminal block.
Fit an earth sleeve to the earth wire.
Insert the wires into the terminal block.
Tighten the screws in the terminal block, ensure the
wires are secure and tight.
Ensure the earth bonding complies with relevant regulations.
L
(Live) = Brown wire
(Protective Earth) = Green /Yellow sleeved wire
N
(Neutral) = Blue wire
Terminal Block (LH)
Terminal Block (RH)
5
6
7
8
Summary of Contents for Mira Jump 10.5 kW
Page 2: ...2 1490289 W2 A ...
Page 30: ...30 1490289 W2 A Notes ...
Page 31: ...31 1490289 W2 A Notes ...
