KODI KLIP KTA-3 Series, Owner'S/Operator'S Manual

Page: 7 / 24

- 7 -
A. OPERATING THE TOOL
1. After the entire Manual has been read and the information is fully understood, connect
the Tool to the air supply.
See Figure #1 Below
TOOL OPERATION
Figure #1: Connecting the Air Supply
The Male Plug should always be connected to the Tool’s Inlet
so that the Tool will depressurize when disconnected from the
Air Supply.
Although the Tool’s Inlet is 1/4 ″ (.635 cm) we recommend using
3/8 ″ ( .95 cm) air hose if supply hose is longer than 8′ (2.4 m).
Compressed air is an invisible hazard. Any Tool, hose or other
component through which it passes is capable of releasing an
explosive force which could result in personal injury or death.