DryView 8100 Laser Imager User Guide
3-8
8754020 2000 March Rev. B
Opening and Closing the Upper Hood
If a film should jam in the developer area, you will have to lift the upper hood to clear
the jam.
Open the upper hood as follows:
1. Grasp the hood at the recessed slot below the Local Panel (see View A in Figure
Figure 3-5).
!
Caution
Whenever you raise or lower the hood, grasp it only in the area of the
recessed slot below the Local Panel to avoid possibly pinching your fingers.
2. Raise the hood until the prop rod falls into the slot at the end of its travel (see
View B in Figure Figure 3-5).
Close the hood as follows:
1. Raise the hood slightly to lift the prop rod out of its slot, and pull the prop rod
slightly forward from the slot.
!
Caution
Close the hood carefully. Releasing and dropping it could damage the laser.
2. Gently lower the hood to its closed position.