Getting Started
1–32
January 1998
Setting up an EtherTalk Connection
Use the PORTS:ETHERTALK menu to establish information about
connecting the printer through an EtherTalk connection. The new option
will be in place once you exit Setup mode. The only options available in
this submenu are E–TALK:VERSION and E–TALK:EXIT.
NOTE: This menu option will appear only if the Network Interface Card is
installed in the printer.
E–TALK:VERSION—This menu specifies whether version 1 or 2 of
AppleTalk will be used on the EtherTalk connection. The following
settings are available.
VER:2*
VER:1
VER:EXIT
Select VER:EXIT once you have made your selection, and E–TALK:EXIT
when you are done.
Setting up an IPX (Novell NetWare) Connection
Use the PORTS:IPX menu to establish the framing type the printer should
expect. The new option will be in place once you exit Setup mode.
NOTE: This menu option will appear only if the Network Interface Card is
installed in the printer.
The following settings are available.
IPX:802.3
IPX:802.2
IPX:SNAP
IPX:ETHERNET 2
IPX:AUTOSELECT*
IPX:EXIT
Select IPX:EXIT when you are done.
