Page 3-19
Dynamic Acera 03/05 Rev. 05
a. M (Manual) mode
This mode senses the movement of con-
trol lever and is suitable for the heavy
load digging work giving priority to the
work load at high speed.
RIGHT HAND OPERATOR CONSOLE
1. Key Switch – FIGURE 3.14.a
The Key Switch is located on the right hand
operator console and has 5 operating func-
tions.
a.
“HEAT ”–This position is used for start-
ing the engine in cold climates.
b.
“OFF ”–When Key is turned to this posi-
tion, the engine stops and electrical
power to the machine’s electrical sys-
tems is stopped after approximately 4
seconds.
c.
“ACC ”–With key in the “ACC ”position
only the cigarette lighter, tuner and horn
will have power.
d.
“ON”– When Key is in the ON position,
electrical power is supplied to all the
machine ’s electrical systems.
e.
“START ”–When key is turned to this po-
sition electrical power is supplied to the
starter solenoid causing the starter to
start the engine. After engine starts key
should be released to go back to the
“ON ” position.
2 . KPSS Mode Switch – FIGURE 3.14.b
The KPSS Mode Switch SK160~SK480 is lo-
cated on the right hand operator console and has
3 operating functions. After starting the engine, the
mode switch defaults to the
M
for maximum power.
The operator can select an effective work mode
complying with the working conditions and work-
ing target from 3 modes. Each time the work mode
switch is pressed, the work mode indicator lamp
is switched from
M,
to
A,
then to
B
in that order.
The following information provides a brief de-
scription and function of the components and
controls of the KOBELCO SK210(LC)-VI Hydrau-
lic Excavator.
All personnel associated with this machine should
read and understand this information BEFORE
beginning any work with or on this equipment.
FIGURE 3.14.a
MACHINE FAMILIARIZATION
COMPONENT & CONTROLS NOMENCLATURE
NOTE
SK480
A
Assist mode reduces engine and
pump yield to approximately 90% of maximum
output.
KPSS MODE SWITCH
KPSS Mode
ED190
Blade Runner
SK160LC
KPSS MODE
SWITCH
FIGURE 3.14.b
NOTE
To clear fault codes on the ED190 press the travel
speed change switch and the buzzer stop switch
at the same time. The new rocker switch for the
Mode/Buzzer Stop switch makes it impossible to
press both switches at the same time.