OPERATION
10
ANGLE CUTTING (BEVELING) (Fig. 22)
1. Layout or secure design to work piece.
2. Move the blade guard foot to the highest position by
loosening the height adjustment knob (1). Retighten.
3. Tilt the table to the desired angle by loosening the table
bevel lock handle (2). Move the table to the proper angle
using the degree scale and the pointer (3).
4. Tighten the table bevel lock handle (2).
5. Loosen the blade guard screw, and tilt the blade guard
to the same angle as the table. Retighten the blade guard
screw.
6. Position the work piece on the right side of the blade.
Lower the blade guard foot against the surface by
loosening the height adjustment knob. Retighten.
7. Follow steps 5 to 7 under Freehand cutting.
1
2
Fig. 22
INTERIOR CUTTING (Fig. 23)
1. Lay out the design on the work piece. Drill a 1/4” hole
in the work piece.
2. Remove the blade. See Blade removal and installation.
3. Place the work piece on the saw table with the hole in
the work piece over the access hole in the table.
4. Install a blade through the hole in the work piece.
5. Follow steps 3-7, under Freehand cutting.
6. When finished making the interior scroll cuts simply turn
the scroll saw OFF. Unplug the saw before removing
the blade from the blade holder. Remove the work piece
from the table.
RIP OR STRAIGHT LINE CUTTING (Fig. 24)
1. Raise the blade guard foot (1) by loosening the height
adjustment knob (2).
2. Measure from the tip of the blade to the desired distance.
Position the straight edge parallel to the blade at that
distance.
3. Clamp the straight edge to the table.
4. Recheck your measurements using the work piece to be
cut and make sure the straight edge is secure.
5. Position the work piece against the blade and place the
blade guard foot against the top surface of the work
piece.
6. Secure the blade guard foot in place by tightening
the height adjustment knob.
7. Remove the work piece from the blade prior to turning
the scroll saw ON.
Fig. 23
2
1
Fig. 24
