5
ASSEMBLY AND ADJUSTMENTS
UNPACKING
Carefully unpack the scroll saw and all of its parts. Compare
them against the list below. Do not discard the carton or any
packaging until the scroll saw is completely assembled.
CAUTION:
do not lift the saw by the arm that holds the blade.
The saw will be damaged.
WARNING
To avoid injury from accidental startups,
turn switch OFF and remove the plug from the power
source outlet before making any adjustments.
A
B
C
INCLUDES (Fig. 1)
A - Scroll saw with attached light
B - Extra pin blade
Fig. 1
STORAGE AREA (Fig. 2)
A convenient storage location
for the extra blade can be found
beneath the saw’s table.
Fig. 2
Prior to making adjustments, mount the scroll saw on a stable
surface. See “Bench mounting the saw.”
ALIGN THE BEVEL INDICATOR (Fig. 3-6)
The bevel indicator has been factory adjusted. It should be
rechecked prior to use for best operation.
1. Remove the blade guard foot (1) using a Phillips head
screwdriver (not included) to loosen the screw (2).
2. Loosen the table bevel lock knob (3) and move the table
until it is approximately at a right angle to the blade.
3. Loosen the locking nut (5) on the table adjusting screw (6)
under the table by turning it counter-clockwise. Lower the
table adjusting screw by turning it clockwise.
4. Use a combination square (7) to set the table exactly
90° to the blade (8). If there is space between the square
and blade, adjust the table angle until the space is closed.
5. Lock the table bevel lock knob under the table (3)
to prevent movement.
6. Tighten the adjusting screw under the table until the tip
of the screw touches the table. Tighten the lock nut.
Fig. 3
1
2
Fig. 4
4
3
Fig. 5
6
5